Abstract: Acid mine drainage (AMD) from abandoned underground mines significantly impairs water quality in the Tones Branch watershed in McCreary Co., Kentucky, USA. A 1022-m(2) surface-flow wetland was constructed in 1989 to reduce the I AMD effects, however, the system failed after six months due to insufficient utilization of the treatment area, inadequate alkalinity production and metal overloading. In an attempt to improve treatment efficiencies, a renovation project was designed incorporating two anoxic limestone drains (ALDs) and a series of anaerobic subsurface drains that promote vertical now or mine water through a successive alkalinity producing system (SAPS) of limestone beds overlain by organic compost. Analytical results from the 19-month post-renovation period are very encouraging. Mean iron concentrations have decreased from 787 to 39 mg l(-1), pH increased from 3.38 to 6.46 and acidity has been reduced from 2244 to 199 mg l(-1) (CaCO3 equivalent). Mass removal rates averaged 98% for Al, 95% for Fe, 94% for acidity, 55% for sulfate and 49% for Mn during the study period. The results indicate increased alkalinity production from limestone dissolution and longer residence time have contributed to sufficient buffering and metal retention. The combination of ALDs and SAPS technologies used in the renovation and the sequence in which they were implemented within the wetland system proved to be an adequate and very promising design for the treatment of this and other sources of high metal load AMD.

Abstract: Flooding partially oxidized mine tailings for the purpose of mitigating further oxidation of sulfide minerals and generation of acid drainage is generally preceded by treatment with alkaline amendments to prevent releasing previously accumulated acidity to the water cover. This work compares the ability of calcite (CaCO3) and quicklime (CaO), two common amendments, to establish and maintain pH conditions and dissolved metal concentrations within environmentally acceptable ranges over long time periods. Although higher initial pH values were obtained with quicklime, the pH of quicklime treated tailings decreased over time. This was attributed to the low buffering capacity of quicklime treated tailings and to the consumption of hydroxide ions by incongruent dissolution of water-insoluble iron oxyhydroxysulfate minerals. In contrast, the pH of tailings treated with calcite increased initially and then remained stable at pH approximate to 6.7. This pH behavior was due to the lower reactivity of iron oxyhydroxysulfates with calcite, the increased buffering capacity provided by bicarbonate ions, and the incomplete dissolution of calcite. Overall, calcite was found preferable to quicklime for maintaining long-term neutral pH conditions in the treated tailings. With the exception of zinc, acceptable dissolved metal concentrations were achieved with calcite treated tailings.

Abstract: Rapid oxidation and accretion of iron onto high surface area media has been investigated as a potential passive treatment option for ferruginous, net-alkaline minewaters. Two pilot-scale reactors were installed at a site in County Durham, UK. Each 2.0m high cylinder contained different high surface area plastic trickling filter media. Ferruginous minewater was fed downwards over the media at various flow-rates with the objective of establishing the efficiency of iron removal at different loading rates. Residence time of water within the reactors was between 70 and 360s depending on the flow-rate (1 and 12l/min, respectively). Average influent total iron concentration for the duration of these experiments was 1.43mg/l (range 1.08-1.84mg/l; n=16), whilst effluent iron concentrations averaged 0.41mg/l (range 0.20-1.04mg/l; n=15) for Reactor A and 0.38mg/l (range 0.11-0.93mg/l; n=16) for Reactor B. There is a strong correlation between influent iron load and iron removal rate. Even at the highest loading rates (approximately 31.6g/day) 43% and 49% of the total iron load was removed in Reactors A and B, respectively. At low manganese loading rates (approximately 0.50-0.90g/day) over 50% of the manganese was removed in Reactor B. Iron removal rate (g/m3/d) increases linearly with loading rate (g/day) up to 14g/d and the slope of the line indicates that a mean of 85% of the iron is removed. In conclusion, it appears that the oxidation and accretion of ochre on high surface area media may be a promising alternative passive technology to constructed wetlands at certain sites.